MadMaxx made this great video describing his experiences with Prusa Mendel. Because he described several problems and raised some questions he received a lot of negative comments on this video.
He did told me on twitter that he was intentionally controversial to start the debate which is important for open source community. Without discussion there is no progress and that is the point that some of his commentators do not understand. They just went into attack mode "HOW DARE YOU TALK ABOUT PROBLEMS!!!!!.
Problems he describes:
I don't't have lot of experience with Prusa Mendel, but I read or heard about most of those problems, but never tough of them as design issues. I just never connected the dots.
Many of those problems can be solved with upgrades and later Prusa Mendel designs made improvements to address those issues. And there is the Prusa I3 :-)
Source:
http://www.youtube.com/watch?v=IQuUqd9ldUU
Let's talk abut problems. Criticism is free consulting.
Here are videos by Allen Jetter that describe how he improved his Prusa Mendel and changes / upgrades he made. He invested lot of work and time. It doesn't solve all problems mentioned above and raises some new issues, but it is good illustration on hove to move ahead.
He did told me on twitter that he was intentionally controversial to start the debate which is important for open source community. Without discussion there is no progress and that is the point that some of his commentators do not understand. They just went into attack mode "HOW DARE YOU TALK ABOUT PROBLEMS!!!!!.
Problems he describes:
- Hanging Z-axis
- Two Z-axis motors
- Lots of wire strain
- Hard to maintain - easy to mess up
- X axis wobble
I don't't have lot of experience with Prusa Mendel, but I read or heard about most of those problems, but never tough of them as design issues. I just never connected the dots.
Many of those problems can be solved with upgrades and later Prusa Mendel designs made improvements to address those issues. And there is the Prusa I3 :-)
Source:
http://www.youtube.com/watch?v=IQuUqd9ldUU
Let's talk abut problems. Criticism is free consulting.
Here are videos by Allen Jetter that describe how he improved his Prusa Mendel and changes / upgrades he made. He invested lot of work and time. It doesn't solve all problems mentioned above and raises some new issues, but it is good illustration on hove to move ahead.